The 10th International Portafold & Ansfold Gathering (i.e. 2018)

Following the huge success of the 9th International Gathering we'll be at Retrofestival again. It's a massive show now and is popular with everyone.

It's held at the Newbury Showground, Priors Court, Hermitage, Thatcham, West Berkshire, RG18 9QZ; on the weekend of the 10th, 11th & 12th of August 2018.

Don't book with the organisers, contact me to get your pitch saved.

Table legs

Any talk that's not covered by the other forums.
Post Reply
The Gomersalls
Posts: 23
Joined: Sun, 14 Sep 2014, 8:08 pm
Location: Sheffield, South Yorkshire

Table legs

Post by The Gomersalls » Mon, 20 Oct 2014, 10:25 pm

Hi, we have a table with our Portafold which came with a selection of dansette style legs but none of them are the correct height to use the table in the van.

Can anyone advise us what length the legs should be, and has anyone found suitable replacements?

Thanks

Marie & John

User avatar
Admin
Posts: 666
Joined: Sun, 05 Nov 2006, 8:53 pm
Location: Christchurch, Dorset

Re: Table legs

Post by Admin » Wed, 22 Oct 2014, 4:08 pm

If you have the original three legged table, you should have one long and two short legs. The long one goes on the floor, the two short sit into small holes in the edge of the locker, each side of the walkway.

You can also use four long legs on an original sink unit, so it can be put up in the awning outside.

Not come across any replacement legs or fittings yet unfortunately.
Matthew
portafold.co.uk
----------------------------------------------------------------------------------
Wanted: Any original Portafold, Ansfold or Mini-Motel brochures, adverts or magazine articles.
Also, any chassis numbers for the above caravans!

The Gomersalls
Posts: 23
Joined: Sun, 14 Sep 2014, 8:08 pm
Location: Sheffield, South Yorkshire

Re: Table legs

Post by The Gomersalls » Wed, 22 Oct 2014, 5:20 pm

Thanks for the reply, our table unfortunately cant have the original legs as it has a set of short ones (about 5 inch) which make it too low to get your knees under when resting on the edges, and if you add one of the long ones it then sits at a strange lopsided angle. They all have the flexible feet too which I don't think original ones have from the photos we have seen, hence it would be good if we can find out what size they should be.

User avatar
Admin
Posts: 666
Joined: Sun, 05 Nov 2006, 8:53 pm
Location: Christchurch, Dorset

Re: Table legs

Post by Admin » Wed, 22 Oct 2014, 6:17 pm

Bad time of year to ask I'm afraid, mine's away for the winter now, but I should be opening it up again at some point to do a few jobs. When I do I'll measure the legs for you.
Matthew
portafold.co.uk
----------------------------------------------------------------------------------
Wanted: Any original Portafold, Ansfold or Mini-Motel brochures, adverts or magazine articles.
Also, any chassis numbers for the above caravans!

The Gomersalls
Posts: 23
Joined: Sun, 14 Sep 2014, 8:08 pm
Location: Sheffield, South Yorkshire

Re: Table legs

Post by The Gomersalls » Wed, 22 Oct 2014, 8:40 pm

Thank you.

RayH
Posts: 23
Joined: Sat, 13 Oct 2012, 2:54 pm
Location: Ascot, Berkshire

Re: Table legs

Post by RayH » Thu, 23 Oct 2014, 5:56 pm

Hi, on mine, the 2 short legs are 11 inches long and the long one is 23 inches - I think that they are original.
Cheers
Ray

The Gomersalls
Posts: 23
Joined: Sun, 14 Sep 2014, 8:08 pm
Location: Sheffield, South Yorkshire

Re: Table legs

Post by The Gomersalls » Thu, 23 Oct 2014, 8:49 pm

Thanks Ray, gives us something to look at this winter.

Post Reply

Who is online

Users browsing this forum: No registered users